Hioki 3196 - Page 101

1
2
3
4
5
6
7
8
9
10
11
Measurement Method
6.5 Detecting Transients and Waveform Distortion
95
(2) Displaying the transient waveform
The screen is divided into two screens, and the lower one switches
from current waveform display to transient waveform display. You
cannot display the transient waveform display unless the voltage/
current screen is displayed.
Transient
waveform
(VIEW voltage/current screen)
You can switch
to the current
waveform dis-
play.
Selecting a specific transient from among multiple event categories
To change the transient waveform’s amplitude and display interval
Scrolling transient waveforms
Methods for changing the amplitude and number of waves for volt
-
age waveforms, measuring the cursor, and scrolling
Use the same method as with three-phase checking.
❖ To change the waveform’s amplitude and its number of waves(page 62
)
❖ To measure the cursor(page 62)(Only for current waveform display.)
❖ To scroll the waveform(page 62)(Only for current waveform display.)
Returning from the VIEW screen to the EVENT screen
Selects a transient to be displayed in the voltage waveform.
The mark is displayed where the transient occurred on the
voltage waveform screen.
Changing the amplitude: x1/2, x1, x2, x4, x8, x16
Changing the display interval: 25, 50,100, 200, 400
µs/d
iv