6.5 Detecting Transients and Waveform Distortion
94
Quick Start Manual
11.
Analyzing waveforms in which events are detected
(1) Displays the event waveform
LIST
Methods for changing the amplitude and number of waveform
cycles, measuring the cursor, and scrolling
Use the same method as with three-phase checking.
❖ To change the waveform’s amplitude and its number of waves(page 62)
❖ To measure the cursor(page 62)
❖ To scroll the waveform(page 62)
Returning from the VIEW screen to the EVENT screen
Event occurrence display
For voltage waveform comparison event occurrences: Wave
(The channel that the event occurred on is displayed.)
For voltage transient event occurrences: Tran
(The channel that the event occurred on is displayed.)
Displays the
waveform for the
event occur-
rence.
Select the number
that you want to
display from the
event list.
VIEW screen dis-
play for an event
occurrence
Indicator
•WAVE
•VECTOR
•DMM
• HARMONICS
You can scroll to display the waveform at the point
where the threshold was exceeded.
To Next Page
Loading...
