6.6
∆
V10 Flicker
100
Quick Start Manual
(2) To check how ∆ V10 flicker is varying
GRAPH
You can only record the channel that is selected as the flicker mea-
surement channel.
The vertical and horizontal scales of the fluctuation graph change auto
matically during recording.
If you want to change the vertical scale, you can do so while recording
is in progress; however, you must first stop recording if you want to
change the horizontal scale.
The
∆ V10 flicker value is calculated once a minute without gaps,
regardless of the set interval time.
You can confirm the contents of settings (SYSTEM-DF2) and wave-
form display (VIEW-DF1/2/3/4) during recording, but you cannot
change them.
When you want to change the settings, you must stop recording first.
Recording start time
Shows the ∆V10 values
every 1 minutes.
8.
Ending the recording interval
Use the same method as when measuring power fluctuation. (page 68)
To Next Page
Loading...
