6.2 Change in Power
68
Quick Start Manual
(2) Confirming voltage and current waveforms during record-
ing
8.
Ending the recording interval
VOLT/CURR
You can confirm the setting contents (SYSTEM-DF2) and wave
form display (VIEW-DF1/2/3/4) during recording, but you canno
change the contents of setting.
When you want to change the setting contents, you must stop
recording first.
When recording was started manually
:
Press this when you want to end recording.
(You can end recording regardless of the presently displayed screen.)
When set to record using real-time control:
Recording ends automatically when the recording end time is
reached.
ANALYZING]
If the internal memory becomes full (when the memory is full and
"STOP" is selected) or the PC card memory becomes full (when the
memory is full and "LOOP" is selected), recording ends automatically
To end recording and start it again
Start recording
In this case, recorded data is deleted. Therefore, to preserve
data, be sure to save it to a PC Card.
Recorded data is erased whenever the instrument is turned
off. Therefore, to preserve recorded data, be sure to save it to
a PC Card.
❖ Data Recording, Saving, Loading and Deleting(page 53)
RECORDING]
To Next Page
Loading...
