98
Preparing to Use an Interface (Connection and Settings)
8.2 Preparing to Use an Interface (Connection and
Settings)
Using the USB interface
Preparation process
(1) Set the instrument’s communications conditions.
(2) Install the USB driver on the computer. (p. 99)
(When using the USB COM setting only)
(3) Connect the USB cable. (p. 99)
Before connecting the instrument to the computer, you must install the USB driver on the
included CD-ROM on the computer. Connecting the instrument to the computer before the driver
has been installed will cause the standard USB driver that Microsoft ships with Windows to be
automatically installed. The instrument cannot communicate properly with the standard Windows
USB driver.
(1) Set the communications conditions.
(Measurement screen) MENU > I/F
1
2
3
Select the transmission mode.
COM
(Rear panel)
(Default setting)
Select if connecting the
instrument to the computer
with a USB cable and
communicating using a virtual
COM port (when outputting
data using a terminal emulator
or a user-created program).
KEYBD
(Rear panel)
Select if connecting the
instrument to the computer with
a USB cable and outputting
data (when outputting data as if
it were typed using a keyboard
into a text editor or spreadsheet
software).
MEMORY
(Front panel)
Select if outputting data to a
USB ash drive. (p. 115)
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
