147
Printing
12.4 Printing
Before printing, check the instrument’s settings (p. 146) to be sure they are correct.
Print parameters
The parameters that are set to be output as described in “9.3 Data Output Settings” (p. 113) will be
printed. (Default setting: V [voltage value] only)
If the comparator function or BIN function is set to ON, judgment results will also be printed.
If you have congured the instrument to output the time and date, set the “DIP SW2 settings”
(p. 145) print mode setting to condensed print (80-row).
Output format
Printed data will conform to the format set as described in “7.8 Setting Output Formats” (p. 92).
Printing from the instrument’s touch panel
Touching PRINT will cause the data to be printed.
To print measured values used in statistical calculations
See “Displaying, clearing, and printing statistical calculation results” (p. 85).
Printingusingexternalcontrol
Turning the PRINT signal on with the instrument (by shorting the EXT I/O connector’s ISO_COM
pin and PRINT pin) enables printing of measured values and judgment results.
To print data as desired
Turn on the PRINT signal when you wish to print data.
To print after the completion
of measurement using the
trigger function
Short the EOM signal with the PRINT signal before starting
measurement. Then input the trigger while the trigger source is set to
EXTERNAL. (p. 38)
To prevent print signal chatter
See “Input lter” (p. 136).
Printing
12
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
