Hioki DM7275 Series - X84; Measurement Error Detection Order

47
Measurement Error Displays (Displays Other Than Measured Values)
Measurement error detection order
Measurement errors are detected in the order shown in the diagram below. The rst error that is
detected will be displayed on the screen and output as a signal from the EXT I/O.
Order Measurement error
detection
Screendisplay EXTI/Oconnector
1
Temperature
compensation error
Yes
Err.TC ERR signal output
No
2
Display:Higherthan
upper limit
Yes
+OvrRng
HI signal output
(When comparator is ON)
No
3
Display:Lowerthan
lower limit
Yes
−OvrRng
LO signal output
(When comparator is ON)
No
4 Contact error
Yes
NoCntct ERR signal output
No
5 No measurement data
Yes
−−−−−−− No output
3
Measurement
w ww . . co m
information@itm.com1.800.561.8187