118
Outputting Data (USB Flash Drive)
10.5 Outputting Data (USB Flash Drive)
Outputting measurement data or screenshots
Touch SAVE to output the measurement data* or screenshot* as of the time you touched the button
to the USB ash drive.
*The output format reects the output format setting (p. 117).
You can also take a screenshot by pressing and holding the [TRIG] key for 2 seconds.
(You can take screenshots with the [TRIG] key even if the output format is set to TEXTDATA.)
The following actions cause a new save le to be created:
• Inserting a USB ash drive while the instrument is on
(Even if there are already les on the USB ash drive, a new folder will be created.)
• Turning on the instrument with a USB ash drive already inserted
Measurement data will be appended to a single le until the number of data points in the le
reaches 10000, at which point a new le will be created automatically.
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
