Hioki DM7275 Series - X84; to Check Judgments Aurally

55
Comparator Measurement (Using a Single Judgment Standard)
Tocheckjudgmentsaurally
(Measurement screen) MENU > MATH > COMP
1 2
BUZZERHI
Tone for HI judgments
BUZZER IN Tone for IN judgments
BUZZERLO
Tone for LO judgments
Set the tone for each judgment and the number
of tones to be sounded.
3
Selectthetypeofjudgmenttonetouse.
(Default setting: OFF)
4
Select the number of times the selected
tone should be sounded.
CONT: Continuous tone
(Default setting: 2)
When the contact check is set to ON, the
buzzer will stop when the measurement
cable is in the open state.
5
To change the buzzer volume: See “7.2 Buzzer Settings” (p. 88).
4
Judging Measured Values
w ww . . co m
information@itm.com1.800.561.8187