Hioki DM7275 Series - Setting The Interface; Setting The Output Data Type

117
Setting the Interface
10.3 Setting the Interface
Before outputting data to a USB ash drive, you must set the interface to USB ash drive mode.
When using a USB ash drive, the USB connector on the rear of the instrument cannot be used.
(Measurement screen) MENU > I/F
1 2
3
When USB COM or USBKEYBD is selected, data cannot be saved on a USB ash drive.
10.4 SettingtheOutputDataType
This section describes how to set the type of data to output to the USB ash drive.
(Measurement screen) MENU > FILE
Selecttheoutputdatatype.
SCREEN COPY Outputs the contents of the
instrument’s screen as a
BMP file.
TEXTDATA
Outputs measured values
as text data (default
setting).
To change the output format
See “7 Setting Output Formats”
(p. 92).
10
Using a USB Flash Drive
w ww . . co m
information@itm.com1.800.561.8187