Hioki DM7275 Series - Selecting Startup Load Settings and a Panel

91
Selecting Startup Load Settings and a Panel
7.7 SelectingStartupLoadSettingsandaPanel
You can choose which settings to load when the instrument starts up.
(Measurement screen) MENU > SYSTEM
1 2
LAST Starts up with the last settings
in use when the instrument was
turned off (default setting).
FACTORY Starts up with the factory settings.
Panel data, system and interface
settings will not be initialized.
PANEL Loads the specied panel.
3
(When PANEL is selected)
1
2
Specifythepanelnumber.
˄ Increases the value by 1.
˅ Decreases the value by 1.
CLR Resets the value to 0.
CANCEL Cancels the setting and returns
to the previous screen.
Valid setting range: 1 to 30 (default setting: 1)
If a panel number that has not been saved is specied, the instrument will not load the panel and
will instead start up with the settings that were in effect when it was turned off (same operation as
for the LAST setting).
7
System Settings
w ww . . co m
information@itm.com1.800.561.8187