Hioki DM7275 Series - Connecting the Temperature Sensor

27
Connecting the Temperature Sensor
2.5 Connecting the Temperature Sensor
Before connecting the temperature sensor, read “Before connecting a temperature sensor” (p. 9)
carefully.
If you wish to measure temperature or use the temperature compensation function, connect the
temperature sensor to the instrument’s TEMP.SENSOR connector.
You will need: Z2001 Temperature Sensor (optional)
(1) Connect the temperature sensor.
Rear
1
Z2001 Temperature Sensor
Measurement
target
2
3
TEMP.SENSOR connector
1
Turn off the main power switch.
2
Connect the temperature sensor to the TEMP.SENSOR connector.
3
Position the end of the temperature sensor close to the measurement target.
4
Press the [V/°C]keytodisplaythetemperature.
(2)Verifythemeasuredvalue.
After turning on the power, check whether the temperature measured value is correct.
For more information: “Switching the measured value display” (p. 18), “Measured temperature is
not displayed correctly.” (p. 171)
The temperature display is updated together with the voltage display.
2
Preparing for Measurement
w ww . . co m
information@itm.com1.800.561.8187