Hioki DM7275 Series - Page 102

100
Preparing to Use an Interface (Connection and Settings)
Using the RS-232C interface
Preparation process
(1) Set the instrument’s communications conditions.
(2) Conguretheexternaldevicethatwillbeconnectedtotheinstrument.
(3) Connect the RS-232C cable. (p. 101)
(1) Set the communications conditions.
(Measurement screen) MENU > I/F
1 2
3
Select the transfer speed (baud rate).
(Default setting: 9600 [bps])
(2) Conguretheexternaldevicethatwillbeconnectedtotheinstrument
(computer,programmablecontroller,etc.).
Be sure to congure the following settings on the device:
Method Asynchronous
Transfer speed 9600 bps / 19200 bps / 38400 bps (same as instrument setting)
Stop bits 1
Data bits 8
Paritycheck
None
Flow control None
w ww . . co m
information@itm.com1.800.561.8187