122
Outputting and Loading Measurement Conditions (USB Flash Drive)
Loadingmeasurementconditions
This section describes how to load measurement conditions stored on a USB ash drive into the
instrument. Communications settings are not loaded.
(Measurement screen) MENU > FILE
1
2
Select the measurement conditions.
File content varies with the extension:
.SET: Measurement conditions
.ALL: Measurement conditions and panel data
3
4
Select whether to load interface settings.
Checked Loads interface settings.
Notchecked
Does not load interface
settings.
5
Touch
OK to replace the instrument’ settings
with the loaded measurement settings.
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
