Hioki DM7275 Series - Page 170

171
Q&A (Frequently Asked Questions)
No. Issue Itemstocheck Possiblecauses→Solutions See
2-6 Measured
temperature is not
displayed correctly.
Temperature sensor There is a problem with the
connection.
→ Connect the temperature sensor
by inserting the plug all the way in.
The specied temperature sensor
has not been used.
→ Use the Z2001 Temperature
Sensor.
p. 27
The temperature sensor is
defective.
→ Replace the Z2001 Temperature
Sensor.
-
Sub-display Trend and settings
screens
Temperature cannot be displayed
on the trend display or settings
screens.
→ Close the trend display or
settings screen.
p. 16
2-6 Measured
temperature is not
displayed correctly.
STOP or EXTERNAL trigger Temperature is updated based on
the voltage. Temperature will not
be updated when measurement is
stopped.
→ Push [TRIG] key to execute
triggered measurements or restart
continuous measurements.
p. 37
p. 38
3. Communications
Operation can be easily conrmed by referring to “8.3 Communications Settings” (p. 109).
No. Issue Itemstocheck Possiblecauses→Solutions See
3-1 The instrument is
not responding at
all.
Display REMOTE icon is not
displayed
Connection is not established.
→ Check whether the connector
has been connected.
-
→ Check whether the interface
setting is correct.
p. 98
p. 100
p. 102
p. 104
(USB)→ Install the driver in the
control device.
p. 98
(RS-232C)→ Use a cross cable. p. 101
(USB, RS-232C)→ Check the COM
port number on the control device.
p. 98
p. 100
(RS-232C)→ Use the same
communication speed for the
instrument and the control device.
p. 100
REMOTE icon is
displayed
Commands are not accepted.
→ Check the software delimiter.
-
→ (GP-IB) Check the message
terminator setting.
→ (GP-IB) Check whether
the address setting has been
congured properly.
p. 102
Maintenance and Service
14
w ww . . co m
information@itm.com1.800.561.8187