5.1 Recording Measurement Data
116
11. Insulation resistance measurement stops
under one of the three conditions below.
1. Time equal to recording interval x maximum
number of loggings has elapsed.
2. The set time of the timer has elapsed.
3. The key is pressed.
After measurement has been completed,
the data No. blinks.
Data is not stored in the memory at this
point.
12. Measure temperature, if necessary. This
may be omitted.
Temperature and humidity measured with
external thermometer and hygrometer
may be entered by key operation.
See 3.4 "Measuring Temperature" (page 82).
See 6.3 "Entering Temperature and Humidity
Measured with External Thermometer and
Hygrometer" (page 131).
• If measurement is stopped before the
first recording interval elapses, no log-
ging records are acquired and [
MEMO
No.
] and the data No. are turned off.
• When the data No. blinks upon com-
pletion of measurement, if [
LObAt
]
appears due to low battery or if power
is turned off by the auto power off, the
data will be stored in the memory.
To Next Page
Loading...
