80
Communicating with PC
A virtual COM port on the PC is used for the USB interface. The virtual COM ports
the instrument can recognized on are COM1 to COM256.
Communications method Asynchronous serial communications over infrared (half duplex)
Content Data saved in the instrument’s memory
Speed 9600 bps
Data length 8 bits
Stop bit 1
Parity bit None
Delimiter CR+LF
Installing the USB driver
Before connecting the instrument to a PC for the rst time, be sure to install the
special USB driver on the PC. The USB driver can be downloaded from the software
download page at Hioki’s website.
https://www.hioki.com/global/support/download/software/
Installing the Sequence Maker
Before connecting the instrument to a PC for the rst time, be sure to install
Sequence Maker on the PC. You can download this software from the following
special Sequence Marker website.
For details on the operating procedures and other information, see the website.
https://sequencemaker.hioki.com/
Installing the Instrument Memory Download Tool
You can use communications commands and the Instrument Memory Download Tool
to change the settings in the instrument and to retrieve saved data.
A list of communications commands can be found in the Instrument Memory
Download Tool le.
Download the Instrument Memory Download Tool from the software download page
at Hioki’s website.
https://www.hioki.com/global/support/download/software/
To Next Page
