9.3 Troubleshooting
93
3
9
Chapter 9 Maintenance and Service
Logger settings cannot be
changed.
Dead battery.
When the battery indicator ap-
pears, settings cannot be changed (but
only displayed). Replace the battery.
"2.1 Installing (or Replacing) the Bat-
tery" (p.17)
How can the logger's mem-
ory be erased?
Logger memory can be erased using
the LR5000 Utility Program.
See: "Other Settings on the Logger
Settings Screen" (p.38)
Note that data recorded prior to the
last recording is automatically erased
whenever recording starts.
(The logger retains the data from both
current and most recent prior record-
ing operation.)
See: "4.3 Starting and Stopping
Recording" (p.42)
How can recorded values
be reorganized?
Enable scaling.
See: "5.1 Scaling" (p.63)
Scaling settings can be made before
recording.
See: "Scaling (set as needed)"
(p.36)
Recorded data has disap-
peared.
Recording was restarted after
stopping.
Note that if recording is accidentally
restarted after stopping, data record-
ed prior to the last recording is auto-
matically erased. (The logger retains
the data from both current and most
recent prior recording operations.)
Before requesting repairs
Problem Symptom Probable Causes Remedies and References
To Next Page
Loading...
