Chapter 11 Specifications
153
11
(12)Comparator Beeper Setting
(13)Auto Hold Function
(14)Panel Save, Panel Load
(15)Reset Functions
(16)Self-Test
Operation Sounds a beeper based on the comparator judgment result.
Operation settings and
tones
Hi : type 1/ type 2/ type 3/ OFF
IN : type 1/ type 2/ type 3/ OFF
Lo : type 1/ type 2/ type 3/ OFF
Number of beeps Hi : 1 to 5 times / continuous
IN : 1 to 5 times / continuous
Lo : 1 to 5 times / continuous
Default setting Hi: OFF, 2times, IN: OFF, 2times, Lo: OFF, 2times
Operation Holds measured values automatically (only when the internal trigger source is
selected and the continuous measurement is set to ON [Free-Run]).
The hold is canceled when the measurement leads are removed from the tar-
get and the next measurement performed, when the range is changed, or when
the ESC key is pressed.
Operation setting ON/ OFF
Default setting OFF
Operation Saves and loads measurement conditions using user-specified panel num-
bers.
Number of panels 10
Panel names 10 characters (letters or numbers)
Saved data Resistance measurement range, measurement speed, zero-adjustment, aver-
age, comparator, judgment sound, scaling, temperature correction, Auto Hold
Loading of zero-adjust-
ment values
ON/ OFF
Default setting ON
Reset
Operation Resets settings (except panel data) to factory defaults
System reset
Operation Reverts all settings, including panel data, to their default values.
At power-on ROM/RAM check, measurement circuit's protective fuse check
To Next Page
Loading...
