Installation BRS20/30/40/50
Release
02
11/2018
31
1.4 Power supply
1.4.1 Supply voltage with characteristic value T
The following options for power supply are available:
6-pin terminal block
You will find information on connecting the supply voltage here:
See “Supply voltage with characteristic value T” on page 43.
1.4.2 Supply voltage with characteristic value F
The following options for power supply are available:
6-pin terminal block
You will find information on connecting the supply voltage here:
See “Supply voltage with characteristic value F” on page 44.
1.5 Ethernet ports
You can connect end devices and other segments to the device ports using
twisted pair cables or optical fibers (F/O).
1.5.1 10/100 Mbit/s twisted pair port
The 10/100 Mbit/s twisted pair port allows you to connect network
components according to the IEEE 802.3 10BASE-T/100BASE-TX standard.
This port supports:
Autonegotiation
Autopolarity
Autocrossing
10 Mbit/s half-duplex mode, 10 Mbit/s full duplex mode
100 Mbit/s half-duplex mode, 100 Mbit/s full duplex mode
Delivery state: Autonegotiation activated
The port casing is electrically connected to the front panel.
The pin assignment corresponds to MDI-X.
1.5.2 10/100/1000 Mbit/s twisted pair port
This port is an RJ45 socket.
The 10/100/1000 Mbit/s twisted pair port allows you to connect network
components according to the IEEE 802.3 10BASE-T/100BASE-TX/
1000BASE-T standard.
This port supports:
Autonegotiation
Autopolarity
Autocrossing
10 Mbit/s half-duplex mode, 10 Mbit/s full duplex mode
To Next Page
Loading...
Need help?
General
