Hirschmann Manitex vSCALE D3 - SLI Setup and Configuration

Operation
5.3 SLI setup
The SLI must be reset to the current crane set-up status after commissioning and after any change
to the crane configuration by completing the full SETUP procedure. The process is step-by-step
and is menu-guided.
WARNING
Imminent threat of personal injury and damage to property due to incorrect system settings!
The correct adjustment of the SLI to the current set-up status is essential for the correct
function of the system and of the crane.
The correctness of these settings must be guaranteed before starting the crane operations!
The description can be found in chapter 4.2 in this manual.
© 2012 Hirschmann Automation and Control GmbH · Mobile Machine Control Solutions · www.hirschmann.com 35/59
50-700-19-2001_422175_en (Manitex)_Rev_B.doc / 2012-03-13 / Issue B / rk.