Operation
5.11 Service menu
The system incorporates a Service menu in which the following settings can be carried out:
Zero point calibration of sensors
NOTE
Safety-relevant settings can only be carried out by authorised personnel after inputting a
password (Service Code).
This prevents inadvertent changes being made to the settings.
Calling up the Service menu from the SLI main menu:
> Password entry
Chapter 4.3 of this manual describes the process for zero-point calibration of the sensors.
Press the “HOME” function key to call up the SLI main menu:
© 2012 Hirschmann Automation and Control GmbH · Mobile Machine Control Solutions · www.hirschmann.com 49/59
50-700-19-2001_422175_en (Manitex)_Rev_B.doc / 2012-03-13 / Issue B / rk.
To Next Page
Loading...