Operation
5.8 Load taring
This function key is used to output the net load to the current load display. The net load is the
current load minus hoisting gear and load block. The “TARE” key must be pressed before
commencing the hoist action.
After actuation, the current load display is set to zero (tared). After hoisting the load, the current
load display then displays the net load (payload). As soon as the load status is changed (by a
change in angle or radius) the display shows the current load again and the taring function is
ended.
NOTE
The current load includes the weight of the load block, the lifting rope and all load-slinging
attachments.
The net load is the actual load on the hook without load-slinging attachments.
Environmental influences can lead to incorrect displays (e.g. wind affecting the boom or
load).
5.9 Switching off alarm
The acoustic alarm can be suppressed for a short period by pressing this function key.
© 2012 Hirschmann Automation and Control GmbH · Mobile Machine Control Solutions · www.hirschmann.com 44/59
50-700-19-2001_422175_en (Manitex)_Rev_B.doc / 2012-03-13 / Issue B / rk.
To Next Page
Loading...