Hirschmann Manitex vSCALE D3 - Adjust SLI to Latest Set-up Status

Commissioning
4.2 Adjust SLI to latest set-up status
The SLI must be adjusted to the current crane set-up status by completing the full SETUP
procedure after start-up (device has been switched off for longer than 2 hours) and after any
change to the crane configuration. The process is step-by-step and is menu-guided. Operation is
with the rotary control.
SETUP procedure
The system is not ready to operate until the full SETUP procedure has been completed.
WARNING
Imminent threat of personal injury and damage to property due to incorrect system settings!
The correct adjustment of the SLI to the current set-up status is essential for the correct
function of the system and of the crane.
The SLI can only operate correctly if all settings are entered correctly according to the
current set-up status during the SETUP procedure.
The settings can only be carried out by operators who are completely familiar with the
operation and functions of the crane and the SLI.
The correctness of these settings must be guaranteed before starting the crane operations!
Depending on the inputs during the SETUP procedure and on various sensor values, the system
automatically determines the corresponding operating mode with the associated lifting capacity
table. The operating mode used by the system at any one time is displayed as a code in the status
row:
Selecting operating
mode
Operating
mode code
The settings made during the SETUP procedure are saved for 2 hours. When the system is
switched back on, e.g. after a short interruption to the work, the settings need simply to be checked
and confirmed.
Saving settings
The process for setting the SLI to the current crane set-up status (SETUP procedure) includes the
following steps:
Process
 Selecting the outrigger and support base
 Selection of the boom configuration and fly jibs
 Selection of the man basket / load block
 Entering the number of rope reevings
 Selection of hoisting winch
 Overview of inputs
© 2012 Hirschmann Automation and Control GmbH · Mobile Machine Control Solutions · www.hirschmann.com 19/59
50-700-19-2001_422175_en (Manitex)_Rev_B.doc / 2012-03-13 / Issue B / rk.