Hirschmann PAT IFLEX5 - Error Codes E60-E69

Error Codes
© Hirschmann Rev. I 05/22/17 190154_I.DOC
67
Error Code
Error
Cause
Elimination
E60
The number of the
selected File base
and the
programmed value
are not identical
 No valid data in the load
chart file
 Upload valid load chart
file
 Base number not
programmed
 Program the correct base
number (1 for base 1, 2
for base 2)
 Load chart file wrongly
programmed
 Check base programming
in the load chart file.
E61
Error in the CAN
bus data transfer for
all CAN units
 CAN Bus cable between
the central unit and the
sensor unit defective or
not connected.
 Check the connection
between the central unit
and the sensor units
 Can bus port in the
central unit defective
 Replace the central unit
 Short circuit in a CAN Bus
cable
 Replace Can Bus cable
E62
Error in the can bus
data transfer of the
pressure transducer
sensor unit
 Cable between the
central unit and the
sensor unit defective.
 Check the cable to the
sensor unit
 Can bus port in the
central unit defective
 Replace the central unit
 Can bus port in the
sensor unit is defective
 Replace the sensor unit
 Sensor unit is defective
 Replace the sensor unit
E63
Error in the can bus
pressure transducer
sensor unit
 The analog values of the
sensor unit are invalid
 Replace the sensor unit
E64
Error in the can bus
data transfer of the
length/angle sensor
unit
 See E62
 See E62
E65
Error in the can bus
length/angle sensor
unit
 See E63
 See E63
E66
Error in the can bus
data transfer of the
2
nd
length/angle
sensor unit
 See E62
 See E62
E67
Error in the can bus
of the 2
nd
length
/angle sensor unit
 See E63
 See E63
E68
Error in the can bus
data transfer of the
force sensor unit
 See E62
 See E62
E69
Error in the can bus
force sensor unit
 See E63
 See E63