Hirschmann PAT IFLEX5 - Error Codes E80-E89

Service Manual iFLEX5
© Hirschmann Rev. I 0522/17 190154_I.DOC
68
Error Code
Error
Cause
Elimination
E80
Error in the slewing
angle measurement
 The difference between
the average of the
slewing angle and one of
the wipers of the slewing
potentiometer is out of
the tolerance
 Check the slewing
potentiometer adjustment
 Replace slewing angle
sensor
E82
Error boom control
task
 The boom control task is
not running
 Restart the system
 Load the boom control
task
E84
Wrong rigging
condition.
 The selected rigging
condition is not contained
in the crane data file.
 Select another rigging
condition
 Check the programming
in the crane data file.
E85
Error in the radius
determination
 The computed radius is
too small (negative
deflection)
 Check the programming
in the crane data file.
E89
Operating mode
switchover with
load.
 The operating mode on
the console has been
switched over with the
boom loaded.
 Select operating mode
without load on the boom