Hirschmann PAT IFLEX5 - Error Codes E95-EC2

Service Manual iFLEX5
© Hirschmann Rev. I 0522/17 190154_I.DOC
70
Error Code
Error
Cause
Elimination
E95
Error in the console
File
 The console File is
defective.
 Replace the console File
E96
Error in the internal
RAM of the console.
 The CPU of the console
is defective.
 The console main board
is defective.
 Replace the CPU of the
console
 Replace the console main
board.
E97
Error in the external
RAM of the console
 The external RAM of the
console is defective.
 The console main board
is defective.
 Replace the external
RAM of the console.
 Replace the console main
board.
E98
LMI watchdog
activated
 LMI processing time limit
exceeded
 Reset system
 Connect PC terminal and
watch error messages
EAB
Short circuit in the
A2B switch circuit
 Short circuit in the A2B
switch
 Short circuit in the cable
to the A2B switch
 Replace A2B switch
 Replace cable to the A2B
switch
EAC
A2B switch circuit
disconnected
 Disconnected cable in the
A2B switch
 Disconnected cable to the
A2B switch
 Connect or replace cable
in the A2B switch
 Connect or replace cable
to the A2B switch
EAD
No valid A2B switch
status
 Sensor wrong function
 CAN bus delay
 Replace A2B switch
 Replace cable to the A2B
switch
EC0
Prohibited area
 Boom is about to collide
with the engine hood,
switch off
 Move boom to permitted
area
 Check values in the data
prom DGA 11.5.
EC1
Approaching
prohibited area
 Boom is about to collide
with the engine hood,
prewarning
 Move boom to permitted
area
 Check values in the data
prom DGA 11.5.
EC2
Angle range of
luffing jib exceeded
 Luffing jib is raised too far
 Luff down the jib to a
angle specified in the load
chart.