Hirschmann qSCALE i2 - Page 20

Troubleshooting
© 2016 Hirschmann Automation and Control GmbH · Mobile Machine Control Solutions · www.beldensolutions.com 20/161
qSCALE i2 Cranes (Tool Version 3.0.34) Service Manual / Issue B / 11-2017 / ac.
3.1.2.1.3 Analog Input Screen
Analog Input Screen shows all of the configured analog inputs for the system, including CAN sensors.
These outputs are wired from the DIO Box; refer to your crane system wiring diagram for details. Use
the rotary knob to scroll between all available outputs.




MAIN
WORKING
SCREEN
OP-MODE
CONFIRM
INFORMATION
SELECTION
SENSOR
INFORMATION
ANALOG
INPUTS
Delete Sensor Calibration
Set Zero Point Offset
Set Current Sensor Raw Value as
Raw-Value Scale Start
Inverts Raw Value
(100% minus raw value)
Set Current Sensor Raw Value as
Raw-Value Scale End
Additional Information
(see Section 3.1.2.1.4)
The following information can be found on this screen:
 Value Current Value
 Fault Indication whether an error has occurred calculating this value
 State Current Status of value
 Substitution According to Project File Configuration
 Scale Scaled values are defined in the configurator
Raw Value Scaling: The start of a raw value scaling is assigned to the scale start value and
changes after sensor calibration
 Deviation Offset changes after sensor calibration
 Gain Filter amplification factor
 Lag Filter delay
 Error Base Base error class and priority of the sensor when an error occurs
Function Keys