Hirschmann qSCALE i2 Service Manual

Appendix
© 2016 Hirschmann Automation and Control GmbH · Mobile Machine Control Solutions · www.beldensolutions.com 79/161
qSCALE i2 Cranes (Tool Version 3.0.34) Service Manual / Issue B / 11-2017 / ac.
Error
Code
Description
Cause
Notice/Solution
1F06
Timeout
Communications failure with external
system
Turn the Ignition off and on again.
Consult Customer Service if the error
occurs again
1F07
Timeout
Communications failure with external
system
Turn the Ignition off and on again.
Consult Customer Service if the error
occurs again
1F08
Timeout
Communications failure with external
system
Turn the Ignition off and on again.
Consult Customer Service if the error
occurs again
1F10
Computer operation error
Internal error in the Application program
Turn the Ignition off and on again.
Consult Customer Service if the error
occurs again
1F11
Computer operation error
Internal error in the Application program
Turn the Ignition off and on again.
Consult Customer Service if the error
occurs again
1F12
Computer operation error
Internal error in the Application program
Turn the Ignition off and on again.
Consult Customer Service if the error
occurs again
1F13
Computer operation error
Internal error in the Application program
Turn the Ignition off and on again.
Consult Customer Service if the error
occurs again
1F14
Computer operation error
Internal error in the Application program
Turn the Ignition off and on again.
Consult Customer Service if the error
occurs again
1F15
Computer operation error
Internal error in the Application program
Turn the Ignition off and on again.
Consult Customer Service if the error
occurs again
1F16
Computer operation error
Internal error in the Application program
Turn the Ignition off and on again.
Consult Customer Service if the error
occurs again
1F17
Wrong data
The machine's data programming does
not fit the application
The system’s data is incorrectly dis-
played. Consult Customer Service if
the error occurs again
1F18
Serial Number wrong or
not set
Serial Number is not set or is invalid
Set Serial Number to valid entry
1F1F
Outputs deactivated
All enabled outputs are deactivated
Information: Subsequent errors result-
ing from another system error
1F2F
Outputs deactivated
All outputs are deactivated
Information: Subsequent errors result-
ing from another system error
1F30
Redundancy error
Disparity between feedback contact and
redundancy monitor
Turn the Ignition off and on again.
Consult Customer Service if the error
occurs again
1F31
Redundancy error
Error in redundancy system 1
Turn the Ignition off and on again.
Consult Customer Service if the error
occurs again
1F32
Redundancy error
Error in redundancy system 2
Turn the Ignition off and on again.
Consult Customer Service if the error
occurs again

Hirschmann qSCALE i2 Specifications

General

Brand	Hirschmann
Model	qSCALE i2
Category	Control Unit
Language	English