45
3.1 Projector Web Control - Network Settings (continued)
3. Web Control
2. Infrastructure settings
Item Description
,3&RQ¿JXUDWLRQ
Con¿gures the network settings of the projector in
Infrastructure mode.
[DHCP ON]
Enables DHCP.
[DHCP OFF]
Disables DHCP.
Con¿gures IP Address, Subnet Mask, Default *ateway
and DNS serYer.
SSID *1 Con¿gures the SSID of Infrastructure mode.
Encryption Selects data encryption method.
WEP Key
Inputs the WEP key.
Either ASCII characters or hexadecimal numbers can
be used.
HoweYer, a combination of both cannot be used.
Encryption ASCII characters HE; numbers
WEP 64bit 5 characters 10 characters
WEP 128bit 13 characters 26 characters
WPA Passphrase *2 Inputs WPA Passphrase.
*1 The text length can be up to 32 alphanumeric characters and symbols. Only
symbols “)*,-./:< >"#[?]AB^_`a and space” can be used.
*2 The text length can be 8 to 63 alphanumeric characters and symbols. Only
symbols “)*,-./:< >"#[?]AB^_`a and space” can be used.
If Encryption /ock is ON, wireless connection is performed only when
it can be connected without changing the current settings.
The channels may Yary depending on the country. In addition, depending on
the country or region, it may be reTuired to use a wireless network card that
conforms to the standards in the respectiYe country or region.
If you connect the projector to an existing network, consult a network
administrator before setting serYer addresses.
The projector does not allow both wireless and wired /AN to be connected to
the same network. Do not set the same network address for both wireless and
wired /AN.
NOTE
To Next Page
Loading...
