Hitachi IJ PH - Page 167

6-30
No
Eliminate the cause of
vibration or shock.
Is any vibration or shock
applied to the IJ printer,
print head, or print head
cable during operation or
startup?
Yes
Does the IJ printer become
ready for printing when you
eject ink and start the IJ
printer with the high-
voltage power supply unit
high-voltage output
FASTON terminal
disconnected?
Replace the high-voltage
power supply unit.
Yes
No
1
Has the ink/makeup ink reached the
print head rear surface?
(See the section on print head operation
and replacement.)
Wipe the entered
ink/makeup ink away with
JK wiper and allow the
print head rear surface to
thoroughly dry.
Yes
No
Replace the EZJ93 board.
Replace the print head.
If the problem is
not fixed:
Replace the high-
voltage power supply.
If the problem is
not fixed:
If the problem is
not fixed:
Replace the EZJ98 board.
If the problem is
not fixed:
Replace the EZJ106 board.