2.2 System environment setup
-The setting with respect to the system environment of the IJ printer is performed.
(1)
Ink type (2) Cable length
(3)
Nozzle size (4) Ink temperature correction
(5)
Excitation frequency (6) Excitation curve
(7)
Ambient temperature upper/lower limit
-
The memory card with the IJP system is necessary to change the nozzle size.
-
This setting is performed in the IJ printer "stop" state.
1 Press System environment setup at the second page of the service
maintenance work screen.
When the previous menu and the next menu are not displayed in the
maintenance work menu, set to the service personnel maintenance mode by the
password protection.
2 Set values using the numeric, Decrement, or Increment key.
When the ink type is set, an initial value is automatically set.
With respect to the initial value, refer to the next page. With respect to
full details about the excitation curve, refer to the attached figure 8.6.
With respect to the
password protection, refer
to "2.1 setting of service
personnel maintenance
mode".
Note
2-4
To Next Page
Loading...
