2-25
2.8 System reset
- Set the default values on the “Printing data,” “User pattern” and “Maintenance” screens.
- Perform this function when the EZJ124 board or the EZJ93 board is replaced in a state
allowing no backup.
- If this function is performed, perform setup and/or adjustment according to the contents
described in “3.2.1 EZJ124 board” and “3.3.1 EZJ93 board.”
1 Press the System reset on the second page of the Service
maintenance screen.
In case the Prev. menu and Next menu are not displayed on the maintenance menu,
change the menu to the Maintenance mode by service personnel with
Password protection.
A confirmation message appears.
3 Press OK
“Wait for a minute” is displayed. After the completion of the system reset, the screen
returns to the service maintenance screen.
To Next Page
Loading...
