Hitachi IJ PH - Battery Low; Product Speed Matching Error

6-36
6.4.4 Battery Low
6.4.5 Product Speed Matching Error
Battery Low
Resume the
operation.
Is the EZJ124 board
CN4 connector
disconnected or in
poor contact?
Yes
No
Replace the battery.
Normality is restored when
the connector is disconnected
and then reconnected.
Product Speed
Matching Error
Resume the
operation.
The frequency of the encoder signal is exceeding the
printing capability of the IJ printer.
Lower the frequency of the encoder signal, or increase its
dividing ratio. Note that the printed character width will
change if the Pulse rate div. Factor is changed.
See 1.5.3-6 ”Rotary encoder signal input” in the Instruction
manual.