Hitachi PH - Page 127

4-4 ● Setting the User Environment
For details about print
output signals, see
Section 1.5.3-8, Print
output signal.
Setup item Description Default
Reverse
print
● Set the print start position when character
position 1 or 3 is set.
(Example)
Printed result when print contents of
[ 1 2 3 4 5 6 7 8 9 0 ]
[A B C ]
are printed with character position 1.
● Line where barcode has been set will always be
printed with method 1.
● Line where the inceased width has been set to 5
to 9 will always be printed with method 1.
● This setting will also function in backward
printing of reverse direction printing mode.
Method 1
Speed
compensation
● This feature can be enabled to prevent print start
delay variations.
● This feature cannot be activated if the product
speed matching feature is disabled.
● It cannot be used in the case where the repeat
print mode is specified on the Print description
screen.
● When the setting of Speed Compensation is set to
"Enable" from "Disable", and print interval is
extremely short, "Print Overlap Fault" error may
occur: Take care.
Disable
Print signal
type
● Performs timing setup for IJ printer status signal
output.
Printing
complete
Method 1
In case of multiple line printing,
print start position will be aligned
to the end of line.
(Print start position will be
different when character position 0
or 2 is set.)
Method 2
In case of multiple line printing,
print start position will be aligned
to the head of line.
(Print start position will be the
same when character position 0 or
2 is set.)
. . . . . . .
Method 1
1 2 3 4 5 6 7 8 9 0
A B C
Method 2
1 2 3 4 5 6 7 8 9 0
A B C
Printing
complete
Generates an output for a fixed
period of time upon completion of
printing.
Printing
in progress
Generates an output during
printing.