4-6 ● Setting the User Environment
(2) Operating procedure
● Setting the output signal to "Print. in progress".
Choose Maintenance from the menu.
The "Maintenance menu" screen then appears.
1
Press Environment setup menu .
The "Environment setup menu" screen then opens.
2
Operations for
modifying the setting
contents
(See Section 2.1.3,
Operations for
modifying the setting
contents. )
Shut
down
Manual
Back
Environment setup
menu
Maintenance menu Status: Ready Com=0
Operation
management
Test print
Excitation V update
(Nozzle test)
View alarm
history
Circulation control
View software
version
Comm. monitor
Password
protection
HOME
Shut
down
Manual
Back
User environment
setup
Environment setup menu Status: Ready Com=0
Date/time setup
Communication
environment setup
Touch screen
setup
Password setup/
update
HOME
Press User environment setup .
The "User environment setup" screen then opens.
3
Shut
down
Manual
Back
Show
cursor
Decre-
ment
Incre-
ment
1234567890
Next
dis-
paly
User environment setup Status: Ready
[ ] (1: )
2:OFF-ON transition)
Reverse direction printing [ 0 ] (0: 1:OFF=ABC 2:OFF=CBA)
Reverse print [ 1 ] (1: 2:method2)
Speed compensation [ 0 ] (0: 1:Enable)
Print signal type [ 1 ] (1: 2:print.-in-progress)
Method to apply print data [ 1 ] (1: 2:method2)
1
Repeat print sensor mode
Prev.
dis-
paly
Signal ON
Disable
method1
Disable
Print. complete
method1
Press Print signal type.
The cursor then moves to the Print signal type field.
4
Press 2 .
The Print sigle type field then reads "print.-in-progress" .
5
Press Apply .
6
Press Back .
The system then returns you to the "Environment setup menu" screen.
7
Cursor will move to the
line you touched.
Selected item on the
cursor-positioned line
can be changed
by touching.
If the cursor is not
displayed, press
Show cursor .
To Next Page
Loading...
