Hitachi PH - Page 182

● Transmission Sequences 6-21
● Target sensor filter
ESC Header 38H
Thousands
position
Hudreds
position
Tens position Units position
Target sensor filter (0000 to 9999)
ESC Header 39H Division
Division (1: time setup, 2: until end of print.)
● High-speed printing
ESC Header 3AH Mode
Mode (0: HM, 1: NM, 2: QM)
● Product speed matching
ESC Header 3BH Based
Based (0: Time-based, 1: Encoder based)
● Pulse rate division Factor
ESC Header 3CH
Hudreds
position
Tens position Units position
Pulse rate division Factor (001 to 999)
● Specifying the print items
ESC Header 24H Item number Print format text
Item number selection (1 to 100)
● Two or more print specification items can be consecutively transmitted in a
single chain.
(3) Print format
a) Print format text structure
● Specifying no print items
Print format text
Set actual item number data as
indicated in the example below.
If the software option "Print digit
addition" is not used, ensure that the
item number does not exceed 24.
Item number1...31H
Item number2...32H
b) Setup items
● Line count and Line spacing
ESC Header 22H Line count Line spacing
Line count
(1 to 4)
Line spacing
(1 to 2)
● Character size and inter-character space
ESC Header 21H Character size Inter-character space
Character size
( 0 to 5)
Inter-character space
(0 to 8)
● Ink drop use percentage
ESC Header 3DH Tens position Units position
Ink drop use percentage (01 to 16)
● Bar code type
ESC Header 2AH Type
Bar code type (30H to 3CH)
Bar code types
30H:Code39
31H:ITF
32H:NW-7
33H:EAN-13
34H:DM16×16
35H:DM8×32
36H:Code128
37H:DM16×36
38H:DM16×48
39H:DM18×18
3AH:DM20×20
3BH:DM22×22
3CH:DM24×24
Character size
0:5×5
1:5×8 (5×7)
2:7×10 (9×8, 9×7)
3:12×16
4:18×24
5:24×32