Make sure that the ink stream is positioned at the center of the
gutter from the side and upper direction as shown in the following
figure.
5
If the ink stream is not positioned at the center of the gutter, perform step 1 to
stop the ink ejection operation, and then proceed as directed in Section 7.6,
Correcting a Bent Ink Stream and Clogged Nozzle.
● When checking the ink stream position, wear protectors (goggles
and mask).
● If the ink or makeup ink should enter your eyes or mouth,
immediately flush with warm or cold water and see a physician.
● Before ejecting the ink, ensure that there is no person in the
direction of ejection. (The end of the print head must be placed in a
beaker or the like.)
WARNING
Install the print head cover.
● If the "Cover open" fault is indicated, press the Erase message key.
6
Switch from "Standby" state to "Ready" state.
7
Enter the print target detection signal and verify the printing
results
(See Section 2.1.1, Strating an operation).
8
Press the Ready key.
Ink Jet Startup Confirmation
The ink jet will be turned ON.
Solution To turn the ink jet ON, press [Ready].
Ready Cancel
To Next Page
Loading...
