Hitachi PH - Page 94

● Printing Characters 3-26
Change the following settings.
This causes the cursor to move to the first line of the second row.
Initial value [AA0001 ]
Range [AA0000 ] Update [000000]
[ZZ9999 ] [000001]
Jump from: [ 1000 ] increment [01]
to: [ 0001 ] Direction [1]
The following counting results are obtained. (Only the digits for which count
setup has been performed are shown.)
Procedure for printing numbers from AA0001-AA1000 through AB0001 to ZZ1000
in the first line of the second row by incrementing the printed number by one after
each printing
Perform steps through of procedure .
1
AA0001 AA0998
.........
AA0002 AA0999
AA1000 AB0998
.........
AB0001 AB0999
AB1000 ZY0998
.........
AC0001 ZY0999
ZY1000 ZZ0999.........ZZ0001 ZZ1000
Press Apply .
3
Press Back twice.
You are then returned to the "Edit message" screen.
4
2
Procedure for printing numbers from AA0001-AA1000 through AB0001 to ZZ1000
in the first line of the second row by incrementing the printed number by one after
each printing
1
1
6
1
2
. .
. .
2
Procedure for printing numbers in increments of 5 from AA0001 through AA9986
in the first line of the second row
Perform steps through of procedure .
1
1 6
1
Change the settings as indicated below.
Value [AA0001 ]
Range [AA0000 ] Update [000000]
[AA9999 ] [000001]
Jump from: [AA9986 ] increment [05]
to: [AA0001 ] Direction [1]
The following counting results are obtained. (Only the digits for which count
setup has been performed are shown.)
2
3
AA0001 AA9981
..........
AA0006 AA9986
(NOTE) Ensure that the jump source setting is the count value for the
increment setting.