In the TEST RUN mode, the red RUN LED of the receiver is turned ON and the green TIMER LED flickers (0.5 seconds
ON ↔ 0.5 seconds OFF) (*2). Then, the timer switches off for two hours.
N O T E
• If the yellow LED does not turn ON, the commands from the remote control switch may not have reached the
receiver. Send the commands again.
• (*2) In the case of the RPK model, the TIMER LED is turned OFF.
5 : Adjust the angle of the air grille as follows. The air louver has a mechanism for the auto-swing function. Do not move
the louver by hand forcefully.
• Select the FAN mode by pressing the MODE switch.
• Set the louver angle by pressing the LOUVER switch.
6 : Stop the test run (normal)
• The test run stops automatically after two hours.
• You stop the test run by pressing the RUN/STOP switch again.
After the test run has finished, check that the red RUN LED and the green TIMER LED turn OFF.
7 : Stop the test run (abnormal) for the PC-RLH 9/11.
If you cannot use the PC-LH3A because of battery shortage or any other reason, perform the emergency operation as
follows.
• COOL switch: Press the COOL switch in order to start the cooling process.
Press the COOL switch again in order to stop the cooling process.
• HEAT switch: Press the HEAT switch in order to start the heating process.
Press the HEAT switch again in order to stop the heating process.
N O T E
During the emergency operation, the yellow LED blinks (0.5 seconds ON / 0.5 seconds OFF).
• Alarm code display
– If some malfunction occurs because of the activation of a safety device or any other reason, the red RUN LED blinks
(0.5 seconds ON / 0.5 seconds OFF).
– Refer to the chapter 8 for the alarm code table.
– The alarm code displays the number of blinks of the green DEF LED and the yellow FILTER LED as shown bellow:
Green DEF LED: Digit 2 of the alarm code blinks.
Yellow FILTER LED: Digit 1 of the alarm code blinks. (Alphabet code: A=10 blinks, B=11 blinks, C=12 blinks, etc.).
– The red RUN LED (1 second ON / 1 second OFF) means that there is an abnormal transmission between the indoor
units and the outdoor unit.
To Next Page
Loading...
