3 Remove the electrical box cover.
4 Removing Electrical Components.
Remove the fixing screw and remove the reactor.
• To mount components, be sure to match the wiring connection with the mark band codes.
1. Electrical box cover.
2. Partition plate.
3. Fuse.
4. Electrical box.
5. Reactor.
6. See the note.
N O T E
• The PCB cannot be removed from the electrical box. To replace PCB, the entire electrical box must be replaced.
• DO NOT touch electrical components while the LED1 (Red) is ON to avoid electrical shock. Wait until the LED
turns off.
10.3.2 Outdoor Units RAS-(4-6)HVRNS1E
¿ Removing service cover
N O T E
Follow the procedure below to remove main parts and components. For mounting, follow the reverse procedure
of removal.
Do not expose the refrigerant cycle to the atmosphere for a long period to avoid moisture or dust entering into the
cycle. Be sure to replace parts immediately after removing. Seal the refrigerant cycle when left unattached for a
long period.
10 Servicing
402
SMGB0060 rev. 1- 12/2010
To Next Page
Loading...
