¿ Installing location where the unit will be exposed to strong wind
Follow the instructions below to install on the roof or in a place which is not surrounded by buildings, and where the product
may be buffeted by strong winds.
1 Select a place where the input or outlet side of the product is exposed to strong winds.
2 When the outlet is exposed to strong winds: Strong direct winds may cause a lack of air flow and negative effects on
the unit operation.
RAS-3HVRNME RAS-(4-6)H(V)RNM1E
RAS-(4-6)HVRNS1E RAS-(8-12)HRNM
RAS-(8/10)HRNSE
C A U T I O N
• An excessively strong wind blowing against the outlet of the outdoor unit may cause reverse rotation and
damage to the fan motor.
2.6.2 Place provision only for RAS-(2-3)HVRN(1)(E)(S)
1 Secure the outdoor unit with the anchor
1. Base of outdoor unit
2. Nut
3. Special washer (M12)
4. Anchor bolts
5. Filled mortar
6. Concrete
A. Max. 17 mm
Fix the outdoor unit to the anchor bolts by special washer of
factory-supplied accessory.
2 When installing the outdoor unit, fix the unit by anchor bolts.
Regarding the location of fixing holes.
1. M10 Hole for anchor bolt (Ø12)
2. Pipe cover
3. Front side
To Next Page
Loading...
