To mount components, be sure to match the wiring connection with the mark band codes.
View from P
10.3.3 Outdoor Units RAS-(8/10)HRNSE
¿ Removing service cover
N O T E
Follow the procedure below to remove main parts and components. For mounting, follow the reverse procedure
of removal.
Do not expose the refrigerant cycle to the atmosphere for a long period to avoid moisture or dust entering into the
cycle. Be sure to replace parts immediately after removing. Seal the refrigerant cycle when left unattached for a
long period.
1 Remove the four (4) fixing screws, slide the service cover
downward and remove.
• Pay attention not to fall of the service cover.
1. Service cover.
To Next Page
Loading...
