Hitachi RAS-3HVRNS - Optional Parts and Installation RAS-3 HVRNME; RAS-(4-6)HVRNS1 E

2.7.2 Optional parts and installation RAS-3HVRNME / RAS-(4-6)HVRNS1E
¿ Air flow guide, wind guard and snow protection hood
Optional parts HP Model
Air flow guide
4-6
AG-335A
1 2
3
1 Air flow guide
2 Wind Guard
3 Snow protection hood
Wind guard
WSP-335A
Snow protection
hood
Zinc plate
Air outlet
4-6
ASG-NP335F
Air inlet of rear side ASG-NP80B
Air inlet of side face ASG-NP80L
Stainless plate
(SUS304)
Air outlet
4-6
ASG-NP335F52
Air inlet of rear side ASG-NP160BS2
Air inlet of side face ASG-NP160LS2
¿ Air flow guide
Specifications
Model
AG-335A
Quantity 1 per unit
1
1
2
1 Mounting dimension
2 Air flow guide
Air discharge
direction
Upward (downward), left & right
Material Weather proof polypropylene resin
Color Gray
Weight 1.9 kg
Accessories
Fixing screw x 4 [M5 (SUS) x 20]
Installation manual
Installation
restriction
“Wind Guard” or “Snow protection hood” is not
available to install with air flow guide. (“Guard net”
is available to be installed together.)
Attaching example of air flow guide
• Attach the air flow guide to the air discharge grille with four (4) screws (supplied).
• The fixing holes are located at 4 positions on the grille. (Screw tightening torque 2.4 ~ 3.1 N.m)
• Do not remove the air discharge grille for air flow guide installation.
C A U T I O N
• If the air guide is installed without discharge grille, it may cause injury due to rotating fan.
2 Unit Installation
33
SMGB0060 rev. 1- 12/2010
2