• Remove the noise filter by clamping the top of the holder (6 portions) with a pincher.
• Identify the terminal numbers with mark band. When reassembling, the terminals have to be connected to the
correct numbers . If incorrectly connected, malfunctions or damages will occur.
10.2.2 Outdoor units RAS-(4-6)H(V)RNM1E
¿ Removing service cover
N O T E
• Remove the main parts according to the following procedures.
– To reassemble perform the procedures in reverse.
– To prevent contamination of the refrigerant with water or foreign particles, do not expose open to
atmosphere for long periods.
– If necessary, seal pipe ends using caps or tape.
1 Remove the four (4) fixing screws.
2 Slide the service cover downward and remove it.
3 Pay attention of not falling off the service cover.
1. Service cover.
¿ Remove air outlet grille
1 Remove the eight (8) fixing screws.
2 Lift the air outlet grille holding the lower parts.
3 Release the extruded hook of the air outlet grille from the
shroud.
1. Air outlet grille.
2. Shroud.
To Next Page
Loading...
