Hitachi RAS-3HVRNS - Procedure for Checking each Main Part; Self-Checking Procedure of PCB by Means of the Remote Control Switch

8.3 Procedure for checking each main part
8.3.1 Self-checking procedure of PCB by means of the Remote Control Switch
Use the following troubleshooting procedure for testing the PCB in the indoor unit and outdoor unit:
If you are using a wireless remote control switch with the built-in receiver part of the wall-type indoor unit and you need to
perform the above checking, perform the following procedure:
1 Turn OFF the power supply.
2 Disconnect the connector (CN25) on PWB(M).
8 Troubleshooting
299
SMGB0060 rev. 1- 12/2010
8