Phenomenon Cause Check item
Action
(Turn OFF Main Switch)
Faulty DIP-IPM Check DIP-IPM by seft-checking Replace DIP-IPM
N O T E
1 For PCB self diagnosis, see Page 420 of “Technical Catalogue/Service Manual”.
2 This alarm (Alarm Code: 38) may appear when the operation is started, if the Faston terminal of the high
pressure switch (63H1) is improperly connected or damaged (open-circuit fault). See also “Alarm Code: 02
Activation of Outdoor Unit Protection Device”
8 Troubleshooting
251
SMGB0060 rev. 1- 12/2010
8
To Next Page
Loading...
