Sequencers
View/Edit Sequence
144 900 Control Station User Guide Revision 9
May 2014
View/Edit Sequence
This display lets you edit parameters of the selected sequence. Edits affect only the currently working
sequence, not the sequence in memory, unless you save the sequence.
ATTENTION
Sequence must be in READY state to edit the values on this display.
Item Description
View/Edit Steps button Accesses View/Edit Sequence Steps (page 145) where you can edit each step.
Sequence Information
Sequence number Memory location of the sequence that is being run by the Sequencer.
Sequence name Name of the selected sequence.
Sequence Desc Description of the sequence.
Jog to Step When the sequencer’s JOG input is triggered, the sequencer will jump to the start
of this step then continue.
Time Units Hours or minutes.
To Next Page
Loading...
