Setpoint Programmers
Overview
120 900 Control Station User Guide Revision 9
May 2014
Setpoint Programmer Overview widgets
Setpoint Programmer data is displayed on the Setpoint Programmer widgets.
Setpoint Programmer Setpoint Programmer with jump
Shows status of the Setpoint Programmer’s
current profile. Use buttons to advance to next
step, run, hold, or reset.
Shows status of the Setpoint Programmer’s
current profile. Use buttons to advance to next
step, run, hold, or reset. Touch blue title bar to
jump to SPP Operate display.
Table 36 Setpoint Progammer Overview widget features
Item Description
Title Name of the selected programmer block. Touch the blue title bar (if
available) to jump to the SPP Operate display. See page 122.
Profile number Location of this profile in controller RAM.
Profile name Name of the selected profile.
State READY: Profile is at the beginning of segment and is ready to run. All
events are OFF.
HOLD: Profile is paused at the setpoint value shown.
RUN: Profile is executing normally.
GHOLD: Profile is paused because of excessive deviation.
STOP: Profile has reached the end of the last segment.
DISABLE: Profile is prevented from starting until the programmer disable
control is ON.
To Next Page
Loading...
