Honeywell ATC928G3000 User Manual

9
Wi-Fi evohome Controller (ATC928G3000)
To bind a Radiator Controller (HR80) to a Wi-Fi evohome
Controller (ATC928G3000) “radiator valve” zone...
On the evohome Controller
1
Press and hold SETTINGS for 5 seconds
2
Press the green tick
3
Press ZONE CONFIGURATION
4
Press on the required zone
5
Press RF DEVICE BINDING
6
Press the forward arrow
On the Radiator Controller
7
Press the recessed bind button on the
underside of the Radiator Controller – it should
briefly show a flashing RF icon then SYNC.
8
Press the recessed bind button again – it
should show a flashing RF icon
On the evohome Controller
9
Press the bind button
The evohome Controller will not show a SUCCESS
message. It’s recommended to perform a
quick functional check to validate the bind.
To do this, adjust the setpoint temperature on
the evohome controller for that zone to the
maximum and minimum, checking the radiator
controller responds to the new setpoint.
Radiator Controller
(HR80)
Wi-Fi evohome Controller
(ATC928G3000)

Honeywell ATC928G3000 Specifications

General

Brand	Honeywell
Model	ATC928G3000
Category	Controller
Language	English